Numbered Report 295 | Texas Water Development Board

Report 295 by E.T. Baker, Jr. | October 1986

  • Report 295 - Hydrology of the Jasper Aquifer in the Southeast Texas Coastal Plain (pdf - 1.96MB)
  • Figure 3 (pdf - 2.16MB) - Stratigraphic and Hydrologic Section A-A'
  • Figure 4 (pdf - 1.94MB) - Stratigraphic and Hydrologic Section B-B'
  • Figure 5 (pdf - 2.09MB) - Stratigraphic and Hydrologic Section C-C'
  • Figure 6 (pdf - 2.05MB) - Stratigraphic and Hydrologic Section D-D'
  • Figure 7 (part A) (pdf - 1.88MB) - Stratigraphic and Hydrologic Section E-E'
  • Figure 7 (part B) (pdf - 2.08MB) - Stratigraphic and Hydrologic Section E-E'
  • Figure 8 (pdf - 2.48MB) - Altitude of the Top of the Jasper Aquifer
  • Figure 9 (pdf - 2.36MB) - Sites where Moderate to Large Volumes of Water are Pumped from the Jasper Aquifer
  • Figure 10 (pdf - 2.44MB) - Hydrographs of Water Levels in Selected Wells Completed in the Jasper Aquifer
  • Figure 11 (pdf - 1.19MB) - Approximate Potentiometric Surface of the Jasper Aquifer Prior to Development by Wells
  • Figure 13 (pdf - 1.16MB) - Boundaries and Grid Patterns of the Model
  • Figure 14 (pdf - 1.07MB) - Approximate Transmissivity in the Part of the Jasper Aquifer Containing Fresh to Slightly Saline Water
  • Figure 15 (pdf - 1.13MB) - Distribution of Net Recharge as Equivalent Precipitation on the Outcrop of the Jasper Aquifer
  • Figure 16 (pdf - 1.32MB) - Vertical-Hydraulic Conductivity of the Burkeville Confining System
  • Figure 17 (pdf - 1.19MB) - Thickness of the Burkeville Confining System
  • Figure 18 (pdf - 1.09MB) - Approximate Potentiometric Surface of the Evangeline Aquifer Prior to Development by Wells
  • Figure 19 (pdf - 1.20MB) - Simulated Potentiometric Surface of the Jasper Aquifer Prior to Development by Wells
  • Figure 20 (pdf - 1.22MB) - Location and Node Designation of a Cross-Section of the Model Used for Sensitivity Analysis
Top